Troubleshooting Ptx5000 Pic Transceivers - Juniper PTX5000 Hardware Manual

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

Troubleshooting PTX5000 PIC Transceivers

IN THIS SECTION

Problem | 628

Solution | 628

A problem has occurred with a PIC transceiver.

To troubleshoot a PIC transceiver:

1. Check the status of the optical transceivers. Issue the show interfaces diagnostics optics command.

Alarms and warnings should be Off.

user@host> show interfaces diagnostics optics

Physical interface: et-0/0/0

Module temperature

Module voltage

Module temperature high alarm

Module temperature low alarm

Module temperature high warning

Module temperature low warning

Module voltage high alarm

Module voltage low alarm

Module voltage high warning

Module voltage low warning

Module not ready alarm

Module low power alarm

Module initialization incomplete alarm

Module fault alarm

PLD Flash initialization fault alarm

Power supply fault alarm

: 39 degrees C / 102 degrees F

Table of Contents