Step 16. Lubricate The Header - MacDon A30-S Assembly Instructions Manual

STEP 16. LUBRICATE THE
HEADER
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
AUGER SHAFT BEARING (1 PLC)
Form # 169078
UNLOADING AND ASSEMBLY
d. Replace
e. If fitting will not take grease, remove and clean
f.
A30-S
High Temp. Extreme Pressure
(EP2) Performance With 1%
Max Molybdenum Disulphide
(NLGI Grade 2).Lithium Base
A30-S HEADER RH SIDE
24
any loose
immediately.
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
Refer to the illustrations on following pages for
lubrication points.
REEL SHAFT BEARING (1 PLC)
or broken fittings
Model Year - 2009