Step 19. Lubricate Header - MacDon A30-S Unloading And Assembly Instructions

STEP 19. LUBRICATE HEADER

a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
AUGER SHAFT BEARING - 1 PLC
169078
UNLOADING AND ASSEMBLY
d. Replace
e. If fitting will not take grease, remove and clean
f.
A30-S HEADER RH SIDE
High Temperature Extreme
Pressure (EP2) Performance With
1% Max Molybdenum Disulphide
(NLGI Grade 2) Lithium Base.
37
any loose
immediately.
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
Refer to illustrations on following pages for
lubrication points.
REEL SHAFT BEARING - 1 PLC
or broken fittings
Revision E