Setting via a program
Use a dedicated instruction to set parameters.
Setting procedure
1.
Use an RIWT instruction to set parameters.
For details on parameters and the procedure for setting parameters, refer to the following.
Page 83 Data that can be read and written in transient transmission
Page 101 Program Example of Setting Parameters Using a Dedicated Instruction
2.
Turn on Initial processing completion flag (RWw0.b8).
3.
Check that the Initial processing request flag (RWr0.b8) is turned off and there is no initial processing request. After the
check, turn off Initial processing completion flag (RWw0.b8).
4.
Check that Remote READY (RWr0.b11) is turned on.
6 Parameter Setting
50
6.2 IO-Link Module Parameter Setting