Omron F3SG-PGA-A User Manual page 215

5.
If the intelligent tap is not connected yet, connect it to F3SG-SR/PG.
Make sure that the configuration is as shown below in the right.
F3SG-SR AND F3SG-PG-A/-L
Wiring for Optical Synchronization without Intelligent Tap
Power Y-Joint
supply
Plug
F3SG-SR AND F3SG-PG-A/-L
Wiring for Wired/Optical Synchronization without
Intelligent Tap
Power
supply
F3SG-PG-C
Wiring for Optical Synchronization without Intelligent Tap
Power
supply
6.
Turn on power of the intelligent tap and F3SG-SR/PG.
Restoration is automatically performed.
7.
Check the indicators on the intelligent tap if restoration is complete.
If the indicators are not proper, turn off power of the intelligent tap, make sure that the wiring is proper,
and go back to step 3. to perform the steps again.
8.
Turn off power of the intelligent tap and F3SG-SR/PG, then turn on power of them.
The settings are not enabled unless the intelligent tap and F3SG-SR/PG are restarted.
9.
Check that F3SG-SR/PG runs as intended.
If it does not, turn off power of the intelligent tap, make sure that the wiring is proper, and go back to
step 3. to perform the steps again.
10.
Turn off power of the intelligent tap and F3SG-SR/PG.
F3SG-SR AND F3SG-PG-A/-L
Wiring for Wired Synchronization with Intelligent Tap
Receiver
Power
supply
Emitter
F3SG-SR AND F3SG-PG-A/-L
Wiring for Optical Synchronization with Intelligent Tap
Power
supply
Emitter
Power
supply
Receiver
F3SG-PG-C
Wiring for Wired Synchronization with Intelligent Tap
Receiver/ Power
supply
Emitter
<Status of indicators at normal end>
OUT :Flashing green at 0.5 second cycle
ERR :Not lit
Setting with Intelligent Tap
Receiver
IT
IT
Receiver
Receiver/
IT
Emitter
IT ： Intelligent Tap
(quick flashing)
F3SG-SR/PG
Emitter
Emitter
E
185
User's Manual