Board Parts: Bottom - Xilinx XtremeDSP Spartan-3A DSP 3400A HW-SD3400A-DSP-DB-UNI-G User Manual

Chapter 1: Introduction

Board Parts: Bottom

X-Ref Target - Figure 1-4
38
Downloaded from Elcodis.com electronic components distributor
Figure 1-4 displays the parts on the bottom of the Spartan-3A DSP 3400A Edition board.
Each numbered item in the diagram is followed by a numbered description.
Figure 1-4: Bottom View of Spartan-3A DSP 3400A Edition Board
1. SPI EEPROM
ST Microelectronics M25P16 16-Mb SPI EEPROM. The device can be used to configure
the FPGA or to hold user data. See
information.
2. DDR2 SDRAM
The Spartan-3A DSP 3400A Edition board is equipped with a single-rank, unregistered
512-MB DDR2 SDRAM. The DDR2 SDRAM is usually a Micron MT8HTF6464HY-53E
or similar. Serial presence detection (SPD) through an I
also supported by the FPGA. See DDR2 memory for details.
FPGA pin assignments used for the DDR2 interface.
Notes:
• Only half the available memory of the DDR2 SDRAM (that is, 256 MB) is available
because of certain limitations.
• The Spartan-3A DSP 3400A Edition board is only tested for DDR2 SDRAM operation
at a data rate of 266 MHz (133 MHz clock rate). Using faster data rates is possible, but
they are untested and not guaranteed.
Chapter 2, "Configuration Options"
www.xilinx.com Spartan-3A DSP 3400A Edition User Guide
4
for detailed
2
C interface to the memory is
Table 1-28 identifies the
UG498 (v2.2) November 17, 2008
R
1
2
3