Conditions Of Crank Disconnect Selection - Smartgen HEM4300 User Manual

No.
3 Level Sensor
4 Vibration Sensor

8.5 CONDITIONS OF CRANK DISCONNECT SELECTION

No.
0 Engine speed
1 Oil pressure
2 Oil pressure + Engine speed
NOTES:
─ There are 2 conditions to make starter disconnected with engine. Engine speed and oil pressure can be used
separately. We recommend that oil pressure should be used with speed sensor together, in order to make the starter
motor separate with engine immediately and can check crank disconnect exactly;
─ Speed sensor is the magnetic equipment installed in starter for detecting flywheel teeth;
─ If engine doesn't have speed sensor please don't select corresponding items, otherwise, "start failure" or "loss speed
signal" may be caused;
─ If engine doesn't have oil pressure sensor, please don't select corresponding items.
HEM4300 Engine Controller User Manual
Items
0 Not used
1 Custom Res Curve
2 Custom (4-20)mA Curve
3 Custom Volt Curve
4 SGD
5 SGH
6 10-130Ω
7 70-10Ω
8 4-180Ω
9 12-170Ω
10 -15 Reserved
0 Not used
1 Custom Res Curve
2 Custom (4-20)mA Curve
3 Custom Volt Curve
4-15 Reserved
Table 14 Crank Disconnect Conditions
Description
Setting Description
Remark
Defined resistance's range is
(0~6)kΩ, default is "Not Used";
Users can select
corresponding curve
themselves.
If pre-set sensor
doesn't support current and
voltage type, then curve type
item 2 and 3
"Reserved".
Defined resistance's range is
(0~6)kΩ, default is "Not Used";
Users can select
corresponding curve
themselves.
If pre-set sensor
doesn't support current and
voltage type, then curve type
item 2 and 3
"Reserved".
Page 44 of 55
the
by
channel
display
the
by
channel
display