Preparing The Cabinet For Installation - Nortel AccessNode 2016 User Manual

3-12 Installation guidelines
Procedure 3-4

Preparing the cabinet for installation

Use this procedure to install the AN2016 cabinet.
Follow the following safety measures when you perform this procedure.
•
•
•
•
•
•
•
•
•
AN2016 Cabinet User Guide
Keep the equipment and the cabinet away from any power lines.
Keep bystanders away from work area at all times.
Use trained operators to operate the equipment for lifting and setting the
cabinet.
Do not suspend loads over people. No person must work, stand, or pass
under a suspended load.
Wear standard safety gear according to local practices, including, but not
limited to, safety helmets, steel-toes shoes, eye protection, and insulating
gloves.
Do not lift the pallet and cabinet from the ends when you use a forklift; lift
from the sides of the pallet only.
Do not operate the crane until all stabilizers are extended and in firm
contact with the ground or adequate support structure. Do not try to retract
or extend the stabilizers while a load is suspended from the crane.
Be alert for overhead obstructions that can interfere with movement of the
crane.
Lift the cabinet with a forklift vehicle placed at the long side of the pallet,
if the cabinet is to be moved while it is attached to the pallet. The forklift
must be rated at 4,000 lb (1,809 kg) and have a minimum fork length of 30
inches (762 mm).
Rel 1.0 Standard May 1999
DANGER
Risk of injury or death
Improper hoisting equipment and procedures can
result in serious injury of death.
—continued—