Interfaces - Sartorius Cubis Series Operating Instructions Manual

Interfaces

62 Operating Instructions Cubis MSE
Interfaces
Purpose
The MSE models have two data interfaces used to output measurement values, cal-
culated values and parameter settings to printers or PCs.
Merkmale of the Interfaces:
– USB interface for a PC connection (PC)
– 25-pin connector for Sartorius accessories (peripherals)
USB Port (PC)
Intended Use
Any PC equipped with a USB port can be connected to a Cubis balance.
A virtual serial interface (virtual COM port) is set up as a device type at the USB
port. There is no difference for the application on the PC whether the serial inter-
face in the PC is built-in or a virtual interface. The interface always functions the
same.
3
The USB port was designed for the office environment and is not suitable for use in
rough industrial environments.
System Requirements
– Computer (PC) running Windows 98SE®, Windows ME®, Windows 2000®,
Windows XP® or Windows Vista®
– Free USB connection
Software Driver and Installation Guides
The enclosed CD contains the software driver.
This driver can be also be downloaded online at:
http:||www.ftdichip.com|FTDrivers.htm
The installation guides for the drivers can be found at:
http:||www.ftdichip.com|Documents|InstallGuides.htm
You can use this driver to install the virtual interface.
Installation
Disconnect the balance from the AC power:
t
unplug the power cord from the wall outlet (mains).
Insert the connection cable into the balance and the PC's USB port.
t
Then reconnect the balance to the power and turn it on (ON).
t
y Windows detects the connected USB cable.
The installation wizard is activated the first time the USB cable is connected.