Sartorius Cubis Series Operating Instructions Manual page 31

isoCAL*: Automatisch kalibrieren und justieren
In the operating menu, select isoCAL-on.
The balance will automatically display a flashing "isoCAL" character whenever the
ambient temperature has changed since the last calibration|adjustment or a time
interval has been exceeded.
The balance wants to perform an automatic adjustment.
The balance will indicate an automatic internal calibration and adjustment is neces-
sary when the following requirements are met:
– Change in temperature or time interval is greater than stated in the table below
– No load change within the last 2 minutes
– The balance has not been used within the last 2 minutes
– The weight on placed on the balance may not exceed 2% of the maximum
load.
The following display appears when the requirements are met:
1. The "isoCAL" symbol is flashing
2. The display indicates CAL.INT. in the measured value line
You can also specify in Setup that only the balance's adjustment message is indi-
cated, without any automatic calibration and adjustment taking place (menu item
NOTE).
isoCAL is switched off on verified models:
In that case, the balance can only be used for legal-for-trade applications within
a limited temperature range.
– Balance of the accuracy class
– Balance of the accuracy class
The fully automatic adjustment function is triggered by the following criteria:
Model
MSE225, MSE225P, MSE125P, MSE324S,
MSE224S, MSE324P, MSE124S, MSE3203P,
MSE2203S, MSE2203P, MSE1203P
MSE623S, MSE623P, MSE323S, MSE10202S,
MSE8202S, MSE6202P, MSE4202S
MSE2202S, MSE1202P
MSA8201S, MSA5201S
The criteria are also set on the corresponding verified models (Models MSE...-0CE).
Using the Balance
k : +15°C to +25°C
K : +10°C to +30°C
When the
temperature
changes by
1.5 °C
2 °C
4 °C
4 °C
Operating Instructions Cubis MSE
After time
intervals of
4 h
6 h
12 h
24 h
31