Table of Contents
Advertisement
Front Panel Features
Front panel features are shown below. Most of the features and LED indications are
described and shown in
with the descriptions of the corresponding rear panel ports.
NOTE: The IPCP 505 must be set up in order to function. See the
IPCP 505
R
Power LED
Reset Button
NOTE: Numbers adjacent to LEDs correspond
to the like-numbered rear panel ports.
Figure 6.
IR Learning Sensor
In most cases, Extron has already produced a driver file for controlling the projector, display,
or source device you plan to use. If a device driver file is not available, you can create your
own using Extron IR Learner software, the remote control of the projector or display, and the
IR learning receiver sensor on the IPCP, shown the figure above.
This receiver accepts infrared signals of from 30 kHz to 1 MHz. The IR remote control must
be pointed directly at the receiver for best results. The front panel diagram indicates the best
distances and angles at which to hold the remote control.
Reset Features
Reset button and LED — Pressing this recessed button causes various IP functions
and Ethernet connection settings to be reset to the factory defaults. The green LED flashes
depending on the selected reset mode (see
on page 18 for details).
Rear Panel Features and Connections
based Configuration and Control
Configurator Help File for information about Global Configurator, which you must use
to set up the unit.
Switched
12 VDC LEDs COM (Serial) LEDs IR/Serial LEDs
COM
SWITCHED
12VDC
LIMIT
1
2
TX
RX
3
4
OVER
1
2
3
4
5
6
7
(recessed)
IPCP 505 Front Panel
section starting on page 20 and the Global
Flex I/O LEDs
RTS
IR/S
RELAY
CTS
1
2
3
4
1
2
3
4
TX
RX
8
5
6
7
8
5
6
7
8
Relay LEDs
Resetting the Unit
IPCP 505 • Hardware Features and Installation
on page 12 paired
Software-
FLEX
100
I/O
1
2
Network
LINK
IR
ACT
3
4
IR Receiver
IR Learning
Angle
and
Distance
2–12"
(4–30 cm)
1
2
3
4
5
6
7
8
9
0
and the reset modes table
LAN/
LEDs
10
Advertisement
Table of Contents
