Table of Contents
Advertisement
6.
Set the maximum number of firmware uploads that can take place at the same time (see
figure 45,
listed in the Select Device list have received new files. The default is 5 uploads at a
time, and the upper limit is the total number of units shown in the Select Device list.
Figure 45.
In the Select Device list, select the devices for the firmware update (
7.
shows an example of a system with IPL 250 units, but the process is identical for the
IPCP.
•
<Ctrl>-click on the names of the units to select (or deselect) more than one unit in
the list.
Click on the name of one unit and <Shift>-click on the name of another unit to
•
select those two IPCPs and the IPCPs listed between them.
8.
Click Browse in the Select Firmware File panel (
firmware file you downloaded in step 1.
9.
Click Begin (
software displays the progress and status of the firmware upload for each unit, then
performs a firmware validation before finishing. If uploading fails, you can view the error
log by clicking on View Log. If uploading is successful, the Status column indicates
success for each unit.
10.
Click Close.
11.
Close the IP Link File Manager software.
Updating Firmware via the IPCP Embedded Web Page
Firmware uploads can be performed via a web browser and the internal web page of the
IPCP controller. This method allows you to update one IPCP at a time via an IP connection.
1.
Download the .s19 firmware file.
2.
Launch a web browser on the connected PC and type the IP address of the controller
in the address area.
). The firmware files are uploaded to this many units at a time until all units
1
Steps 6 through 9: The Firmware Update Manager Window Prior to
Uploading
), then confirm that you want to start uploading the firmware. The
4
). Figure 46
2
), then locate and select the
3
IPCP 505 • Firmware Updates
86
Advertisement
Table of Contents
