Front Panel Features - Extron electronics StudioStation 100 Setup Manual

Front Panel Features

ALARM
USB STORAGE
CONFIG
A C
B
StudioStation 100 Front Panel
Figure 3.
—
Power LED
A
—
Solid Green
•
Blinking green
•
—
B Alarm LED Lights red when one or more alarms are triggered (see the StudioStation 100 User Guide for all alarms).
—
Config port
C Connect a control device to this port with a USB mini-B cable (not supplied). Use this port to send SIS
commands to the StudioStation 100 for device configuration and control.
NOTE: For information on using this port for device configuration and control and for a list of available SIS commands,
see the StudioStation 100 User Guide at www.extron.com.
USB storage port and activity LED
D
port status and blinks during both reading and writing. The storage device can be any standard external hard drive or USB
flash drive formatted with a compatible file system.
NOTE: The StudioStation 100 can detect and record to USB storage devices using FAT32, VFAT long file name
extensions, EXT2, EXT3, EXT4 file system, or NTFS-formatted storage volumes.
—
HDMI LED Lights green when HDMI video input sync is detected.
E
—
HDCP LED
F Lights green when HDCP content is detected.
Audio Signal and Clip LEDs
G
Audio Input Indicators – Red (signal clipping) and green (signal present) LEDs for HDMI and line input channels.
•
Audio Output Indicators – Red (signal clipping) and green (signal present) LEDs for the output channel.
•
For both the Audio Input and Audio Output indicators, the green signal LED varies in brightness corresponding to the
input signal level. It begins to light at – 60 dBFS increasing to full intensity corresponding to signal level increases. When
the signal level reaches – 3 dBFS or above, the red clipping LED lights and remains lit as long as the signal remains
above – 3 dBFS. When it falls below that level, the red LED remains lit briefly, after which the display resumes real-time
monitoring of the signal level.
Record controls with LED indicators
H
—
Record
Press
•
—
Stop Press
•
recorded file is being finalized, then lights steadily when the file is finalized.
—
Pause Press
•
paused. Press Record or press Pause to resume recording or Stop to halt the recording.
—
Mark
Press
•
button blinks momentarily to indicate a chapter marker is inserted. The button also illuminates when JPG thumbnails are
automatically created at 5 minute intervals by default.
G
F
OUT
INPUT
HDCP CLIP
HDMI AUDIO
HDMI LINE HDMI
D E
The power is on and the unit is operational.
—
The power is on but the unit is still booting (not operational).
—
Connect a USB compatible media device to this port. The LED indicates the USB
—
—
Record, Stop, Pause, and Mark indicate the current state of record operation:
to record. The red record button lights steadily during active recording.
to stop the active recording. When pressed during a recording, the green stop button blinks while the
to pause recording. When pressed, the green Pause button blinks to indicate video recording is
to place a chapter marker in the recorded file. When pressed during recording, the green Mark
MARK
H
MARK
StudioStation 100
3