Resetting The Unit - Extron electronics IPCP 505 User Manual

Resetting the Unit

There are five reset modes that are available by pressing the Reset
button on the front panel. The Reset button is recessed, so use a
pointed stylus, ballpoint pen, or Extron Tweeker to access it. See the
reset modes table
ATTENTION:
The reset modes (with the exception of Mode 2) close all open IP and Telnet connections
and close all sockets.
NOTE: If you hold down the Reset button continuously, the LED blinks every 3 seconds,
on the next page for a summary of the modes.
• Review the reset modes carefully. Using the wrong reset mode
may result in unintended loss of flash memory programming, port
reassignment, or an IPCP unit reboot.
• Analysez minutieusement les différents modes de réinitialisation.
[voir tableau page suivante]. Appliquer le mauvais mode
de réinitialisation peut causer une perte inattendue de la
programmation de la mémoire flash, une reconfiguration des
ports ou une réinitialisation du processeur.
and the unit enters a different mode, from Modes 3 through 5.
For Mode 5 (Reset to Factory Defaults) the LED blinks three times, the third blink
indicating the last mode. The modes are separate functions, not a continuation from
Mode 1 to Mode 5.
IPCP 505 • Hardware Features and Installation
R
Power Reset
LED Button
18