Table of Contents
Advertisement
Mounting the IPCP 505
Optional rack shelves are available for use with the IPCP.
Read the
instructions that
come with the rack
shelf or mounting kit
for installation
procedures.
The IPCP 505
includes rubber feet
so it can be set on
a table. If you are
going to mount the
unit to a rack shelf
and these feet were
attached to the
enclosure, remove
the feet before
mounting.
UL Rack Mounting Guidelines
The following
the IPCP 505 in a rack.
1.
2.
3.
4.
5.
Front false
faceplate
uses 2
screws.
Underwriters Laboratories (UL)
Elevated operating ambient temperature — If installed in a closed or multi-unit
rack assembly, the operating ambient temperature of the rack environment may be
greater than room ambient temperature. Therefore, install the IPCP in an environment
compatible with the maximum ambient temperature (Tma = +122 °F, +50 °C) specified
by Extron.
Reduced air flow — Install the equipment in a rack so that the amount of air flow
required for safe operation of the equipment is not compromised.
Mechanical loading — Mount the equipment in the rack so that a hazardous
condition is not achieved due to uneven mechanical loading.
Circuit overloading — Connect the equipment to the supply circuit and consider the
effect that circuit overloading might have on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be used when
addressing this concern.
Reliable earthing (grounding) — Maintain reliable grounding of rack-mounted
equipment. Pay particular attention to supply connections other than direct connections
to the branch circuit (such as use of power strips).
1U Universal Rack Shelf
1/2 Rack Width Front False
Faceplate
Use 2 mounting
holes on opposite
corners.
guidelines pertain to the safe installation of
IPCP 505 • Hardware Features and Installation
(2) 4-40 x 3/16"
Screws
NOTE:
Using screws longer
than 3/16" will damage the
unit and void the warranty.
11
Advertisement
Table of Contents
