Front Panel Features; Quantum Ultra 305, Connect 128, And; Connect 84 - Extron electronics Quantum Ultra Series User Manual

7.
8.
9.
10.

Front Panel Features

Quantum Ultra 305, Connect 128, and Connect 84
The Quantum Ultra Connect 128, Quantum Ultra Connect 84, and Quantum Ultra 305
(figure 4) front panels are identical except for the product name in the lower-right corner.
A
Figure 4.
A
Power on the Quantum Ultra and all connected devices.
Download and install VCS on your computer (see
Software (VCS) Program
The default IP addresses of the Quantum Ultra chassis are:
• LAN A: 192.168.254.254
LAN B: 192.168.1.254
•
Set a new IP address for the Quantum Ultra using any of the following:
• VCS program — The Videowall Configuration Software for the Quantum Ultra
can be downloaded from the Extron website (see
Website on page 74). Run this program on a computer that is connected to
the same network as the Quantum Ultra to assign an IP address to the processor
(see the VCS Help File for instructions).
NOTE: A gateway IP address is required on the PC running VCS for the
Quantum Ultra to be detected. The gateway IP address does not need to
be valid or in the same subnet for the detection to work.
• Internal operating system — The Quantum Ultra is a host device with an
embedded Windows operating system. To interact with the operating system to
change settings, attach peripheral USB devices, such as a keyboard, mouse,
and flash drive, to System USB ports 1, 2, and 3 on the rear panel. Attach an
HDMI monitor to the HDMI Out port beside the System ports to view the settings.
• SIS commands — Using a host communication software program such as the
Extron DataViewer on your computer, enter the appropriate SIS command to set
an IP address or enable DHCP (see
Configure sources, displays, and presets for your videowall system using VCS (see
the VCS Help File).
Quantum Ultra 305 Front Panel
Indicator LED — This tri-color LED lights to indicate the following:
• Green, blinking — The Quantum Ultra 305 is booting.
Green, steady — The unit is ready for operation.
•
• Amber, steady — The system is in power saving mode.
Red, steady — A fan has failed.
•
Quantum Ultra Videowall Processing System • Installation and Configuration
Videowall Configuration
on page 74).
Downloading VCS from the
IP Setup on page 71).
QUANTUM ULTRA 305
VIDEOWALL PROCESSOR
12