Advertisement
DMP 64 Plus • Setup Guide (Continued)
Reset Button and LED — The reset button returns the DMP 64 Plus to different tiers of default states. When using the reset
H
function, the LED blinks to signify the different reset modes. When not using the reset function, the LED operates as a power
indicator and matches the front panel power LED (see the Reset Modes section of the DMP 64 Plus User Guide for more
information on the different reset modes).
Mic/Line Inputs — Use 6-pole 3.5 mm captive screw connectors to connect 6 balanced or unbalanced microphone or mono
I
line level sources (see 6-pole Audio Input Wiring below). Inputs 1 through 6 provide phantom power and AEC.
Tip
Ring
Sleeve
Tip
Ring
Sleeve
Balanced Input
6-pole Audio INPUT Wiring
6-pole Audio Input Wiring
Figure 2.
NOTES:
•
Balanced or unbalanced stereo sources can be connected to the 6-pole inputs.
•
When using the 5-pole CSR adapter, connect it so the far left plug is inserted into the far left jack of the 6-pole
input.
Digital I/O Ports — Connect 6-pole 3.5 mm captive screw connectors to these ports. These configurable digital input and
J
output ports are designed to connect to microphones with logic circuitry for mic mute and tally back functionality. Each port
provides a common ground.
Line Outputs — Use 6-pole 3.5 mm captive screw connectors to connect up to four balanced or unbalanced mono line level
K
devices or two stereo devices (see diagram below).
Tip
Ring
Sleeve
Tip
Ring
Sleeve
Balanced Output
6-pole Audio OUTPUT Wiring
Figure 3.
Audio Output Wiring
ATTENTION:
For unbalanced audio outputs, connect the sleeves to the ground contact. DO NOT connect the
•
sleeves to the negative (-) contacts.
Pour l'audio asymétrique, connectez les manchons au contact au sol. Ne PAS connecter les manchons
•
aux contacts négatifs (–).
When all connections have been made, power up the input and output devices, then apply power to the DMP 64 Plus.
Front Panel Features
ACTIVITY
EXP
CONFIG
USB
A
B
DMP 64 Plus Front Panel
Figure 4.
Power LED — Blinks during boot up and lights steadily when the DMP 64 Plus is operational.
A
USB Config Port — One USB mini-B port is used for configuration. This port can also be used for firmware updates.
B
Activity Indicator LEDs — These LEDs indicate activity or status on the rear panel EXP, LAN, and USB ports.
C
Input Indicator LEDs — Stacked green and red LEDs display input signal presence and input signal clipping.
D
Output Indicator LEDs — Stacked green and red LEDs display output signal presence and output signal clipping.
E
2
Tip
Sleeve
Jumper
Tip
Sleeve
Jumper
Unbalanced Input
Tip
NO Ground Here
Sleeve
Tip
NO Ground Here
Sleeve
Unbalanced Output
INPUTS
1 2 3 4 5 6
LAN 1
CLIP
LAN 2
SIGNAL
C
D
OUTPUTS
1 2 3 4
CLIP
SIGNAL
DIGITAL MATRIX PROCESSOR
E
DMP 64 Plus
Advertisement
