Front Panel Features - Extron electronics EDID 101H 4K PLUS User Manual

Front Panel Features

Figure 1.
A
B
C
D
E
F
G
C
A B
SIGNAL
CONFIG
HDCP
Extron
D
EDID 101H 4K PLUS Front Panel Indicators and Configuration Port
Power LED – Lights when an external power supply is connected and powered.
Config port – Connect a host computer using a mini USB type-B connector for
configuration using SIS commands or the PCS configuration software, and for firmware
updates (see Connecting to the USB Port
Signal LEDs – Lights when a HDMI signal is detected on the input and output.
HDCP LEDs – The In LED Lights when the source device requires HDCP encryption
and the signal has been authenticated, and the Out LED lights when HDCP is
authenticated between the HDMI output and the connected sink device. This only
occurs when the source device requires HDCP and is authenticated.
If the source does not require HDCP or if the sink device is not HDCP compliant, the
LED does not light.
EDID Store LED – Lights steadily when power is connected. It blinks when the unit is
reading and storing EDID from a connected output device, returning to steady when
recording is complete.
EDID Store button – Press this recessed button to initiate reading and storing an EDID.
The EDID is stored to a user slot selected by the rotary switch. Up to four EDID files can
be stored.
Reset To reset the EDID 101H 4K PLUS to its default state, press and hold the
–
button while applying power. As power is applied, all front panel LEDs blink 3
STORE
times indicating a successful reset.
EDID selection rotary switch – One 16-position rotary switch provides a choice of 12
pre-programed EDID files and 4 user stored files (see
and one EDID read from a connected display.
G
E F
EDID
IN OUT
STORE
EDID 101H 4K PLUS
on page 21).
EDID Configuration
EDID 101H 4K PLUS • Installation and Operation
EDID
on page 7),
4