Table of Contents
Advertisement
SIS Programming
and Control
This section covers the following topics:
•
•
The IPCP 505 can be remotely controlled via a host computer, touchpanel, or other device
(such as a control system) attached to a shared network.
The IPCP must be configured before use. As shipped, the controller/processor cannot
control any other devices or interact with a touchpanel until it has been configured. Set up
the IPCP or control it by using Simple Instruction Set (SIS) commands or Global Configurator
software (version 3.2 or higher) via an Ethernet LAN connection (see
protocol
see
files for the software.
IPCP 505 LAN port defaults:
•
•
•
•
Host-to-IPCP Communications
SIS commands consist of one or more characters per field. No special characters are
required to begin or end a command sequence. When the IPCP determines that a
command is valid, it executes the command and sends a response to the host device. All
responses from the IPCP to the host end with a carriage return and a line feed (CR/LF = ] ),
which signals the end of the response character string. A string is one or more characters.
IPCP 505-initiated Messages
If you are communicating with the IPCP via a
event such as a selection via a touchpanel takes place, the IPCP responds by sending a
message to the host. No response is required from the host. The IPCP-initiated messages
are listed here.
(c) Copyright 2013, Extron Electronics, IPCP 505, Vx.xx, 60-1071-02 ]
Day, DD MMM YYYY HH:MM:SS ]
Vx.xx is the firmware version number.
Example:
(c) Copyright 2013, Extron Electronics, IPCP 505, V1.03, 60-1071-02
Mon, 15 Jul 2013 10:49:12
The IPCP 505 sends the boot and copyright messages when you first open a Telnet
connection to the IPCP. The day of the week, date, and time are displayed if the unit is
connected via Telnet. If you use a Telnet connection, the copyright message, date, and time
may be followed by a password prompt.
Host-to-IPCP Communications
Commands and Reponses
on page 14). For information on the software and the embedded web pages,
Software-based Configuration and Control
IP address: 192.168.254.254
Gateway IP address: 0.0.0.0
Subnet mask: 255.255.0.0
DHCP: off
pin assignments and
starting on page 20 and see the help
verbose
Telnet connection, when a local
IPCP 505 • SIS Programming and Control
53
Advertisement
Table of Contents
