Connecting Cables; Connecting Fiber; Figure 5-7 Connecting The Grounding Cable - Raisecom Gazelle S1503i User Manual

Raisecom
Gazelle S1503i (A) User Manual

Figure 5-7 Connecting the grounding cable

5.4 Connecting cables

5.4.1 Connecting fiber

The Gazelle S1503i supports the LC/PC fiber interface.
When the Gazelle S1503i is not used, you should to put the dustproof cover on the
optical interface to prevent dust and dirt from entering the optical interface so as to
make sure that the Gazelle S1503i works normally.
There is invisible laser in the Gazelle S1503i, which may cause eye injury. Therefore,
you should not look directly at the optical interface, head of the optical connector, or
breakage of the fiber.
Inserting optical module
Insert the SFP optical module into the optical interface on the Gazelle S1503i.
Connecting LC/PC fiber
When connecting or removing the LC/PC optical connector, align the connector with the
optical interface, and do not rotate the fiber. The process is as below:
Step 1 Remove the dustproof covers of the optical module and fiber, and keep it for later use.
Step 2 Align the connector with the optical interface to insert the fiber into the optical interface
gently.
Step 3 To remove the fiber, push the fiber connector inwards slightly, and pull out the fiber.
Raisecom Technology Co., Ltd.
5 Hardware installation
38