Connecting Cables; Connecting Lc/Pc Fiber; Connecting Ethernet Cable; Figure 4-20 Connecting The Ethernet Cable - Raisecom Gazelle S1000i-LI User Manual

Table of Contents

Raisecom

Gazelle S1000i-LI (A) User Manual

4.4 Connecting cables

When the Gazelle S1000i-LI is not used, you should put a dustproof cover on the

optical interface to prevent dust and dirt from entering it to ensure that the Gazelle

S1000i-LI works normally.

There is invisible laser in the Gazelle S1000i-LI, which may cause eye injury.

Therefore, you should not look directly at the optical interface, header of the optical

connector, or breakage of the fiber.

Connect the LC/PC fiber as below:

Step 1 Insert the SFP optical module into the optical interface on the Gazelle S1000i-LI.

Step 2 Remove the dustproof covers of the optical module and fiber, and keep it for later use.

Step 3 Align the connector with the optical interface to insert the fiber into the optical interface

gently.

Step 4 To remove the fiber, push the fiber connector inwards slightly, and pull out the fiber.

Connect the Ethernet cable as below:

Step 1 Make the Ethernet cable according to specifications.

Step 2 Align the Ethernet cable header with the Ethernet interface of the Gazelle S1000i-LI and

insert the Ethernet cable into the Ethernet interface gently, as shown in Figure 4-20.

Raisecom Proprietary and Confidential

4 Hardware installation

Table of Contents

Show Quick Links

Table of Contents