Configuring Upnp - Honeywell HEN04112 User Manual

52 | Performance Series Full Poe Embedded NVR Remote User Guide
Setting
Server IP
Port
Username
Password
Anonymous
Remote Directory
File Length
Image Upload
Interval
Channel
Weekday
Time Periods
Recording Type
Click Test to test the FTP connection. A popup window shows the status of the connection.

Configuring UPnP

UPnP allows you to establish the mapping relationship between the LAN and the public network.
Here you can also add, modify, or remove a UPnP item.
Preparing for UPnP
1.
2.
3.
4.
Configuring UPnP
1.
www.honeywell.com/security
Table 3-11 FTP Configurations
Description
Enter the IP address for the server.
Enter the Port number for the server.
Enter the user name for logging into the server.
Enter the password for logging into the server.
Click to enable/disable anonymously logging into the server.
When the remote directory is null, the NVR automatically creates folders
according to the IP, time, and channel.
Here you determine the size of the upload file. If the setup file size is
larger than the actual file, then the system uploads the entire file. If the
setup file size is smaller than the actual file, then the system uploads only
the set file size. If you enter 0 here, then the system uploads all
corresponding files.
This is the interval that the CVR waits through before uploading an image
to the FTP site. Select from 0 to 3600 seconds. 0 means that there is no
interval.
Select a channel.
Select a weekday.
You can configure up to two time periods per channel.
Select from Alarm, Motion, or Regular.
In the Windows OS, click Start
Click Add/Remove Windows Components, and then select Network Services from the
Windows Component Wizard.
Click Details, then check Internet Gateway Device Discovery and Control client and
UPnP User Interface. Then click OK to begin the installation.
Enable UPnP from the internet. If your UPnP is enabled in the Windows OS, then the NVR
can automatically detect it through the My Network Places.
Click UPnP in the NETWORK configuration interface to open the UPnP configuration
interface.
 
Control Panel Add or remove programs.