Honeywell HEN04112 User Manual page 69

00Configuring Net Alarms
Configuration
Enable
Period
Type
Record Channel
Delay
Alarm Out
Latch
Table 3-15 WEB - Alarm Configurations
Description
Click to enable alarms. Select a channel from the drop-down
list.
Define a period during which the alarm is active.
1. Click Set. The Set configuration interface appears.
2. Select a day of the week from the drop-down menu. Select
from a day of the week, Work Day, or Free Day.
Note If you select Work Day or Free Day, a Set button
appears so you can configure which days are Work
Days and which days are Free Days. Click Set, select
the Work Days and the Free Days, then click OK.
Note You can configure up to 6 periods within one day.
3. Configure a time range for when the event detection area
is active, then click the check box to select that time range.
4. Click Save.
Select either NO or NC.
The system automatically starts recording selected channels
when a motion detection alarm occurs.
Note You need to set the alarm recording period.

Go to Storage Schedule to configure the current channel
for scheduled recording. See
page 76.
The system can delay recording for a specified amount of time
after an alarm has ended. Select from 10s to 300s.
Select the device output port, 1 or 2. Select the corresponding
port(s) so the system can activate the corresponding alarm
devices when an alarm occurs.
The system can delay the alarm output for a specified time
after an alarm ends. The value ranges from 1s to 300s.
Configuration | 69
Configuring Local Storage on
800-21261V2 - A - 03/2016