Configuring Ptz Settings - Honeywell HEN04112 User Manual

82 | Performance Series Full Poe Embedded NVR Remote User Guide
RS232 Configurations
1.
2.

Configuring PTZ Settings

Before configuring PTZ, please ensure the following:
•
•
www.honeywell.com/security
Table 3-23 Display Tour Settings
Setting
Window Split
Channel Group
Motion Tour/Alarm Tour
Type
Click RS232 under SETTING to open the RS232 configuration interface.
Figure 3-51 WEB - RS232 Configuration Interface
Table 3-24 RS232 Web Configurations
Setting
Function
Baud Rate
Data Bit
Stop Bit
Parity
Make your selections, then click Save.
The PTZ and decoder are connected correctly, and that the decoder address setup is
correct.
That the correct decoder line is connected to the correct NVR line (A to A; B to B).
Description
Set the window mode and channel group. Depending on your
NVR, it can support up to a 1/4/8/9/16-window split.
Add channels to a channel group, and when the NVR starts a
tour, the tour starts only on the selected channels for the
group.
Set the Motion Detection Tour and Alarm Detection Tour
window modes. The NVR can support 1/8 window.
Description
Select the corresponding dome Protocol. The default is
Console.
Select the Baud Rate. The default is 115200.
Select from 5 to 8. The default is 8.
Choose either 1 or 2. The default is 1.
Select from None, Odd, Even, Space, or Mark. The default is
None.