Configuring Snmp - Honeywell HEN04112 User Manual

Figure 3-17 UPnP Configuration Interface
2. Configure the following settings:
Enable Click to enable or disable UPnP.
LAN IP Enter the NVR's IP address from the TCP/IP page.
WAN IP Enter the router's IP address.
3. (Optional) Add, edit, or delete a mapping relationship from the Port Mapping List:
Add a mapping relationship:
Protocol (TCP or UDP), enter the Internal Port and External Port details, and then click
OK. To ensure data transmission, the internal and external ports should be the same.
Avoid using ports 1 to 255 or 256 to 1023.
Edit a mapping relationship:
then, in the Port Info dialog box, edit the Service Name, Protocol, Internal Port, and/or
External Port details, and then click OK.
Delete a mapping relationship:
and then click Delete.
4. Click Apply to save your settings.
5. Click OK to exit the Setting menu.

Configuring SNMP

SNMP allows the communication between the network management work station software and
the proxy of the managed device. It is reserved for a third party developer.
Click SNMP under NETWORK to open the SNMP configuration interface.
Click Add and then, in the Port Info dialog box, select the
Click the mapping relationship that you want to edit, and
Click the mapping relationship that you want to delete,
Configuration | 53
800-21261V2 - A - 03/2016