Configuring Pppoe - Honeywell HEN04112 User Manual

Table 3-7 CDMA/GPRS Configurations
Configuration
Note If the Pulse Interval is 0, then the system does not end the 3G connection after you
close the extra stream monitor.
Note The Pulse Interval here is for the extra stream only. This field is inactive if you are
using a main stream monitor.
IP Address
Wireless Signal
Configuring the Mobile Settings
Click Mobile Setup under 3G to open the Mobile Setup configuration interface.
Figure 3-11 Mobile Setup Configuration Interface
Activate/deactivate 3G connected phones or mobile phones, or the phone you configured to get
alarm messages.

Configuring PPPoE

1. Click PPPoE under NETWORK to open the PPPoE configuration interface.
Description
Non-configurable. After the NVR connects to the network
through CDMA/GPRS, it receives an IP address, which
displays here.
When the NVR connects to 3G through GPRS/CDMA, by
clicking SEARCH, you can see the signal strength.
Configuration | 45
800-21261V2 - A - 03/2016