Elnec BeeHive8S User Manual page 31

• On
• Off
• Use Project settings
When Automatic YES! mode is
after device operation is com
programmed device and insertion of new device and afterwards automatically start
(repeat) recent operation on new device. So operator does not need to press any key or
button, to program next device.
When Automatic YES! mode is Off, operation on next device can be started manually,
by pressing the YES! button near each programmer site socket. Each programmer site
has its own YES! button.
Status of the active Automatic YES! function is displayed on the bottom left side of LCD
main screen with label Automatic YES! Is On by following:
If the Automatic YES! function is Off, no label about Automatic YES! is displayed.
For more details about Automatic YES! feature see documentation chapter
Programmer / Automatic YES!.
P rogrammer / Select Enabled Sites...
Command displays dialog "Select E
This dialog is used to select sites that have to be used.
c heck box. If the check box #n is checked, it means the site #n is selected, and device
Automatic YES! Is always On
Automatic YES! Is always Off
Automatic YES! setting depends on relevant settings
stored in project file
On, programmer sites are scanning their device sockets
pleted. The control program can detect removing of
nabled Sites".
31
ELNEC s.r.o.
Each te is represented by one si