Elnec BeeHive8S User Manual page 12

• programmed chip voltage (VCCP) with both source/sink capability and voltage sense
• 1x VPP voltage (range 2V..25V/50mA)
• target system supply voltage (range 2V..6V/250mA)
• ESD protection on each pin of ISP connector (IEC1000-4-2: 15kV air, 8
• two output signals
level: min 1.8V)
• input signal, switch YES! equivalent (active level:
DE VICE SUPPORT (valid for each programming module)
P rogrammer
• EPROM: NMOS/CMOS, 2708, 27xxx and 27Cxxx series, with 8/16 bit data width, full
support for LV series
• EEPROM: NMOS/CMOS, 28xxx, 28Cxxx, 27EExxx se
• Flash EPROM: 28Fxxx, 29Cxxx, 29Fxxx, 29BVxxx, 29LVxxx, 29Wxxx, 49Fxxx seri
from 256Kbit to 32Mbit, with 8/16 bit data width, full support for LV series
•
Serial E(E)PROM
93Cxxx, NVM3060, MDAxxx series, full support for LV series
• Configuration (EE)PROM: XCFxxx, XC17xxxx, XC18Vxxx, EPCxxx, AT17xxx, 37
• 1-Wire E(E)PROM: DS1xxx, DS2xxx
• PROM: AMD, Ha
• NV RAM: Dallas DSxxx, SGS/Inmos MKxxx, SIMTEK STKxxx, XICOR 2xxx, ZMD
U63x series
•
PLD: Altera: MAX 3000
• PLD: Lattice: ispGAL22V10x, ispLSI1xxx, ispLSI1xxxEA, ispLSI2xxx, ispLSI2xxxA,
ispLSI2xxxE, ispLSI2xxxV, ispLSI2xxxVE, ispLSI2xxxVL, LC4xxxB/C/V/ZC, M4-xx/xx,
M4A3-xx/xx, M4A5-xx/xx, M4LV-xx/xx
• PLD: Xilinx: XC9500, XC9500XL, XC9500XV, CoolRunner XPLA3, CoolRunner-II
• other PLD: SPLD/CPLD series: AMI, Atmel, AMD-Vantis, Gould, Cypress, ICT, Lattice,
NS, Philips, STM, VLSI, TI
• Microcontrollers 48 series: 87x41, 87x42, 87x48, 87x49, 87
• Microcontrollers 51 series: 87xx, 87Cxxx, 87LVxx, 89Cxxx, 89Sxxx, 89LVxxx, all
manufacturers, Philips LPC series
•
Microcontrolle rs Intel 196 series: 87C196 KB/KC/KD/KT/KR/...
• Microcontrollers Atmel AVR: AT90Sxxxx, ATtiny, ATmega series
• Microcontrollers Cypress: CY7Cxxxxx, CY8Cxxxxx
•
Microcontrollers ELAN: EM78Pxxx
• Microcontrollers MDT 1xxx and 2xxx series
• Microcontrollers Microchip PICmicro: PIC10xxx, PIC12xxx, PIC16xxx, PIC17Cxxx,
PIC18xxx, PIC24xxx, dsPIC series
• Microcontrollers Motorola (Freescale): 68HC05, 68HC08, 68HC11, H
series
• Microcontrollers Myson MTV2xx, 3xx, 4xx and 5xx series
•
Microcontrollers National: COP8xxx
• Microcontrollers NEC: uPD78xxx series
• Microcontrollers Novatek: NT68xxx series
•
Microcontrollers Scenix (Ubicom): S
• Microcontrollers SGS-Thomson: ST6xx, ST7
• Microcontrollers TI: MSP430 and MSC121x s
• Microcontrollers ZILOG: Z86/Z89xxx and Z8xxx series
, which indicate state of work result = LED OK and LED Error (active
: 24Cxxx, 24Fxxx, 25Cxxx, 45Dxxx, 59Cxxx, 25Fxxx, 25Pxxx, 85xxx,
rris, National, Philips/Signetics, Tesla, TI
A, MAX 7000A, MAX 7000B, MAX 7000S, MAX7000AE,MAX II
series
Xxxx series
12
max 0.8V)
ries, with 8/16 bit data width
x50 series
xx, ST10xx, STR7xx series
eries
ELNEC s.r.o.
kV contact)
es,
LVxx
CS08, HCS12