Elnec BeeHive8S User Manual page 29

Each Master operation can consist of a sequence of one or more partial operations, for
example Program device operation can consist of the following sub-operations:
1.Erase
Selection of sub-operations is stored in Project file. For details about project file creation
and usage, refer to Engineering mode chapter.
Preselected device operation can be started by button Run <operation_name>
displayed on main screen.
Menu Programmer
Programmer / Search for pro grammers...
Menu command displays the dialog "Search programmers", which is used to
reinitialize software configuration, and to re-find available programmer sites. There is no
need to use this menu command in normal operation. Situations, when the command is
u seful are:
1. when first starting BeeHive8S
2 . when error message "Programmer Sites not found" is displayed
In the dialog "Search Programmers" use button "Search" to search for attached
p rogrammers. The
dialog. When programmer sites are successfully found, the result shows the
p rogrammer ty pe, and allows you to accept new settings by button Accept. Otherwise
" No Progra m mers found" message will be displayed in table Search results and
button Acc ept is disabled.
2.Program 3.Verify
Stand-Alone multiprogramming system
result of search will be displayed in table Search results in Search
29
ELNEC s.r.o.