Elnec BeeHive8S User Manual page 28

File / Switch to Engineering mode
Command is used to start Pg4uw control program in Engineering mode. In this mode,
user can use Pg4uw software to select any device from the list of supported devices,
set options for the device, load data files for device, test the device operations on any
programmer site and create a project file which can be used in production mode. More
information about Engineering mode is available in chapter Engineering mode.
To switch back to production mode just close Pg4uw control program and run program
Pg4uwMC by double-clicking on Pg4uwMC icon on the Desktop.
Note:
Engineering mode requires connection of external VGA
D o not use this menu option, without these peripherals connected and working.
File / Shut down computer
Command is used to close control program and to shut down built-in c
si milar, to command "Shut down" in Microsoft Windows operating systems.
M enu Device
Device / Predefined operation
This menu allows user to select device Master operation. Following Master operation
are available:
• Blank check
• Verify
• Program
• Erase
28
ELNEC s.r.o.
monitor, keyboard and mouse.
omputer. It is