Elnec BeeHive8S User Manual page 21

When the built-in computer is turned on the operating system will start booting-
3.
up, cooling fans should start to work, and "Wait please" screen should be
displayed on graphical control unit.
4. Starting of the
than 1 minute.
After the operating system has successfully started, the Pg4u
5.
program will start automatically. When the Pg4uwMC is ready to work the
"Welcome" screen is displayed on graphical control unit.
6. Click the OK butt
menus and Status panel should appear on graphical control uni
Checking if the sites are ready to be connected
7. When first starting S
message "Programmer Sites not found" is displayed, then programmer
software must be
menu "Program
8. In dialog Search for Programmers use button "Search" to search for present
programmer sites. The result of search will be displayed in table Search results in
Search dialog. When programmer sites are successfully found, then programmer
type and its serial number is show in the table Search result. Detected
program mer can be accepted by pressing/touching Accept. If no complete
programmer was found, then "No Programmers found" mess
displayed in table Search results and button Accept will be disabled.
9. If search result is "No Programmers found", please try to turn off Stand-Alone
programmer, by menu "File / Shut down computer", turn off the power button on
the back Side of programmer, wait for 15 secon
programmer again. If the search result is still
refer to troubleshooting documentation.
S tarting programm
10. Each programmer site is uses its own
11. To start the hidden applications of control programmer sites, use
"Programmer / Connect Sites".
12. The "Connecting sites" indicator is displayed during connection of sites.
Additional information about site connection progress is displayed for each site in
panel Status on
13. Programmer sites are
of programmer sites from left to right.
14. When connection process of programmer sites is complete, indicator
"Connecting Sites" will be hidden. Panel Status will contain information about
each site.
Loading project file
15. When site status after conn
can begin the Load project operation accessib
The project file can be loaded from default directory [Projects] or from any other
location, for example from USB key. For more details about Load project, refer to
the chapter "Menu File" and Load project. When Load project operation is
successfully done for all Sites, the "Ready" status must be displayed in panel
Status on touch screen for all connected Sites. If there are some Sites with
different status, use troubleshooting documentation to resolve the problem.
Selec tion of predefined device operation
16. Use menu "Device / Predefined operation" to select device Master operation.
Following Master operations are available:
operating system can take some time normally this time is shorter
on on "Welcome" screen to continue. The main screen with
tand-Alone multiprogramming system, or when error
reinitialized by action "Search for Programmers..." available in
mer / Search for Programmers...".
er sites
main screen.
numbered from #1 to #8 in direction of physical placement
ection is "Ready" or "No project file is loaded" user
"No Programmers found", please
hidden control application Pg4uw.
le from menu File / Load project.
21
ELNEC s.r.o.
wMC control
t.
age will be
ds or more and start
menu