Prescribe Frpo D0 Command - Kyocera FS-2000D Advanced Operation Manual

PRESCRIBE FRPO D0 Command

ADVANCED OPERATION GUIDE
The PRESCRIBE FRPO D0 command is provided to allow manipulating
XON/XOFF when an error has occurred on the serial interface. The
following table summarizes the error status corresponding to different D0
values.
Timing of XON transfer to
host while Ready or
Waiting
XON sent every 3-5
seconds
XON not sent
Computer Interface
Serial interface error
error not handled
D0=0 (default) D0=1
D0=10 D0=11
error handled
4-9