Prescribe Frpo D0 Command - Kyocera Ecosys FS-3820N Operation Manual

PRESCRIBE FRPO D0 Command

The PRESCRIBE FRPO D0 command provides control over XON/XOFF
operation when an error occurs on the serial interface. The following table
summarizes the error status corresponding to different D0 values.
Timing of XON transfer to
host while Ready or Waiting
XON sent every 3-5 seconds
XON not sent
Table B-8
Error not handled
D0=0 (default)
D0=10
B-9
RS-232C Protocol
Serial interface error
Error handled
D0=1
D0=11