Kyocera FS-2000D Advanced Operation Manual page 61

ADVANCED OPERATION GUIDE
Enter the submenu by pressing B. Each time
2
you press ? or @, the selection changes.
3
When >>IP Address is displayed, press
[OK]. A blinking cursor (_) appears at the
last digit.
Press ? or @ to increase or decrease, respectively, the value at the
4
blinking cursor. Use B and A to move the cursor right and left.
5
When the IP address is entered, press [OK].
Press ? or @ to move to Subnet Mask. Perform the same procedure to
6
complete entering the subnet mask address.
Then, press ? or @ to move to Gateway. Perform the same procedure
7
to complete entering the gateway address.
8
Press [Menu]. The display returns to Ready. You can print a network
status page to confirm that the IP address, subnet mask address, and the
gateway address have been properly set. To print a network status page,
refer to Printing a Network Interface Status Page on page 2-36.
Using the Operation Panel
>>DHCP
Off
>>BOOTP
Off
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
>>IP Address
000.000.000.000
2-35