Kyocera FS-2000D Advanced Operation Manual page 94

Using the Operation Panel
2-68
A4
Executive
Letter
Legal
7
When the desired paper size is displayed, press [OK]. The paper size is
set for the paper cassette.
If you selected Custom in step 6, be sure to set the unit of measurement
and the dimensions of the paper as described in the following sections.
NOTE:
When you set paper size for the optional feeder, A6 does not
appear.
Selecting the Unit of Measurement
Press B.
1
Press ? or @ repeatedly until >>Unit
2
appears. The unit of measurement can be
selected between millimeters and inches.
The current unit of measurement is
displayed.
3 Press [OK]. A blinking question mark (?)
appears.
Select mm or inch using ? or @.
4
5 Press [OK].
Set the dimensions of the paper as described in the next section.
Entering the Width and Length
1
Enter the paper size for X Dimension and Y Dimension as shown in the
figure.
148 to 216mm
>>Unit
mm
>>Unit
? mm
X Dimension
ADVANCED OPERATION GUIDE