Default Font - Kyocera FS-2000D Advanced Operation Manual

Default Font

ADVANCED OPERATION GUIDE
Select KPDL or KPDL (AUTO) using ? or
4
@.
5 Press [OK].
Press B. Press ? or @ until >Print KPDL
6
Errs (errors) appears.
7 Press [OK]. A blinking question mark (?)
appears.
Select On using ? or @. Press [OK].
8
9 Press [Menu]. The display returns to Ready.
You can select the default font for the current interface. The default font
can be one of the internal fonts or a font that is downloaded to the printer
memory or stored on CompactFlash card, Microdrive or option ROM.
In this menu, you can also set the type and pitch for Courier and Letter
Gothic; as well as to print a font list.
1
Press [Menu].
Press ? or @ repeatedly until Font >
2
appears.
Press B. Press ? or @ until >Font
3
Select > appears.
4
To select an internal font, make sure that
Internal is displayed and press B. The
display changes. If Internal is not
displayed, press [OK], then press ? or @
until it appears.
To select an optional font, press [OK] while >Font Select > is
displayed. Press ? or @ repeatedly until Option appears and then press
[OK]. Press B next to display the font selection shown above. You can
perform this operation only when optional fonts are installed in the printer.
Using the Operation Panel
Emulation
?KPDL
>Print KPDL Errs
Off
>Print KPDL Errs
? Off
Font
>Font Select >
Internal
>> I000
2-39
>