Selecting The Right Paper - Kyocera FS-2000D Advanced Operation Manual

Handling Paper

Selecting the Right Paper

Condition
Composition
Paper Sizes
1-4
This section describes the guidelines for selecting paper.
Avoid using paper that is bent at the edges, curled, dirty, torn, embossed,
or contaminated with lint, clay, or paper shreds.
Use of paper in these conditions can lead to illegible printing and paper
jams, and can shorten the life of the machine. In particular, avoid using
paper with a surface coating or other surface treatment. Paper should have
as smooth and even a surface as possible.
Do not use paper that has been coated or surface-treated and contains
plastic or carbon. The heat of fusing can cause such paper to give off
harmful fumes.
Bond paper should contain at least 80% pulp. Not more than 20% of the
total paper content should consist of cotton or other fibers.
Cassettes and the MP Tray are available for the paper sizes listed in the
table below. The dimensional tolerances are ±0.7mm for the length and
width. The angle at the corners must be 90° ±0.2°.
MP tray
Envelope Monarch 3
Envelope #10 4
ISO A6 105 × 148mm
Envelope DL 110 × 220mm
Envelope #9 3
Envelope #6 3
JIS B6 128 × 182mm
Statement 5
Hagaki 100 × 148mm
Ofuku-Hagaki 148 × 200mm
Youkei 2 114 × 162mm
Youkei 4 105 × 235mm
Cassette or
Size
MP tray
× 7 inches Legal
7/8 1/2
× 9 inches Letter
1/8 1/2
ISO A4
ISO A5
× 8 inches ISO A6
7/8 7/8
× 6 inches Envelope C5
5/8 1/2
ISO B5
× 8 inches JIS B5
1/2 1/2
Executive
Oficio II
Folio
16 kai
Size
8 × 14 inches
1/2
8 × 11 inches
1/2
210 × 297mm
148 × 210mm
105 × 148mm
(FS-2000D: MP tray
only)
162 × 229mm
176 × 250mm
182 × 257mm
7 × 10
1/4 1/2
8 × 13 inches
1/2
210 × 330mm
197 × 273mm
ADVANCED OPERATION GUIDE
inches