Kyocera FS-2000D Advanced Operation Manual page 48

Using the Operation Panel
Printing a Private Print/Stored Job
2-22
Printing Remaining Copies of a Proof and Hold Job
Printing a Proof-and-Hold job on the operation panel is similar to printing a
quick copy job. Refer to Printing Additional Copies using Quick Copy on
page 2-20
In private printing, you can specify that a job is not printed until you release
the job from the operation panel. When sending the job from the
application software, specify a 4-digit access code in the printer driver. The
job is released for printing by entering the access code on the operation
panel ensuring confidentiality of the print job.
In the stored job mode, access codes are not mandatory, but can be set
on the printer driver if printing with PIN security is required. Then, the
access code must be entered on the operation panel to print a stored job.
Print data will be stored in the Microdrive after printing.
Releasing a Private/Stored Job
1 Press [Menu].
Press ? or @ repeatedly until e-MPS >
2
appears.
Press B.
3
Press ? or @ repeatedly until >Private/
4
Stored appears. The name entered in the
printer driver (Harold, in this example) also
appears.
5 Press [OK]. A blinking question mark (?)
appears before the user name.
Press ? or @ to display the desired user
6
name (Arlen, in this example).
7 Press [OK]. The user name and the job
name (Agenda, in this example) entered in
the printer driver appear with a blinking
question mark (?).
Press ? or @ to display the desired job title.
8
e-MPS
>Private/Stored
Harold
>Private/Stored
?Harold
>Private/Stored
?Arlen
>Arlen
?Agenda
ADVANCED OPERATION GUIDE
>