Message Display - Kyocera FS-2000D Advanced Operation Manual

Using the Operation Panel

Message Display

Message
Self test
Please wait
Please wait
(Adding toner)
Ready
Processing
Sleeping
Skipping data
Waiting
FormFeed TimeOut
2-4
The message display on the operation panel shows:
• Status information, the messages listed below which are displayed
during normal operation.
• Error codes, when the printer requires the operator's attention; as
explained in the Operation Guide.
Status Information
The printer is performing self-diagnostics after power-up.
The printer is warming up and is not ready. This message may be displayed
during continuous printing of a large volume of pages which require a large
amount of toner such as with photographs, etc.
Toner is currently being replenished.
When the printer is switched on for the first time, this message will take several
minutes.
The printer is ready to print.
The printer is receiving data to print. This is also shown when the printer is
reading a CompactFlash card, Microdrive, RAM disk, or USB flash memory.
The printer is in Auto Sleep. The printer wakes from Auto Sleep whenever a key
on the operation panel and [GO] is pressed, the cover is opened or closed, or a
print job is received. The printer then warms up and goes on-line. For details on
Auto Sleep, refer to Sleep Timer Timeout Time on page 2-80.
The printer is skipping the data.
The printer is waiting for the rest of print job before completing the last page.
Pressing [GO] allows you to obtain the last page immediately. Refer to below.
The printer is printing the last page after a waiting period.
Error codes
Refer to the Troubleshooting section in the Operation Guide.
Meaning
ADVANCED OPERATION GUIDE