Changing The Interface Parameters - Kyocera FS-2000D Advanced Operation Manual

Using the Operation Panel

Changing the Interface Parameters

Changing Parallel Interface Mode
2-30
This printer is equipped with a parallel interface, a USB interface and a
network interface (FS-3900DN/FS-4000DN). An optional serial interface
and a network interface can be installed. Various printing environment
parameters such as the default emulation can be changed independently
on different interfaces by using the printer's menu selection system. Select
the interface to apply the changes in the procedure described below.
NOTE:
This interface selection described below does not select the
interface from which data will be received. The printer automatically
selects the interface
The parallel interface supports a bi-directional/high-speed mode according
to IEEE standards. Normally, this interface is used under the default setting
Auto. For details, refer to Parallel Interface on page 4-3. After setting the
interface, be sure to reset the printer or turn the power off at least once.
The new setting will be enabled thereafter. You can select from the
following:
• Auto (default)
• Nibble (high)
• High speed
• Normal
1 Press [Menu].
Press ? or @ repeatedly until Interface > appears.
2
3
If the interface is other than parallel, press
[OK]. A blinking question mark (?) appears.
Press ? or @ repeatedly until Parallel
4
appears.
5 Press [OK] again. The question mark disappears.
To change the parallel interface mode, press B. The current
6
communication mode appears.
7
To change the communication mode, press
[OK]. A blinking question mark (?) appears.
.
ADVANCED OPERATION GUIDE
Interface
? Serial
Interface
? Parallel
>Parallel I/F
? Nibble (high)