Kyocera FS-2000D Advanced Operation Manual page 49

ADVANCED OPERATION GUIDE
9 Press [OK]. The ID input line appears.
Enter the four-digit access code entered in
the printer driver and press [OK].
To enter the ID, press ? or @ to move the
cursor to the number to be changed and then enter the correct number by
pressing ? or @.
10 You can set the number of copies to be
printed. To increase the copy count, press
?; to decrease the copy count, press @.
11 Press [OK] to finalize the copy count. The printer prints the specified
number of copies for the job.
Deleting a Private/Stored Job
You can individually delete stored jobs by performing the following
procedure. Jobs saved using Private Print will be automatically deleted if
you turn the power off after printing, but jobs saved using Stored Job will
not be deleted automatically.
1
Follow steps 1 through 8 in the above section.
2
When the title of the job to be printed is
displayed (Agenda, in this example), press
[OK]. Enter the four-digit access code
entered in the printer driver and press [OK].
Press @ repeatedly until Delete appears
3
for the number of copies.
4
Press [OK]. The private job is deleted from the Microdrive.
Printing a Code Job
To print a code job, ensure that the KM-NET for Clients is installed on the
computer. The KM-NET for Clients is provided on the Software Library
CD-ROM.
Using the Operation Panel
>Agenda
ID 0000
>Agenda
Copies 001
>Agenda
Copies 001
>Agenda
Delete
2-23