Paper Handling - Kyocera FS-2000D Advanced Operation Manual

Using the Operation Panel

Paper Handling

MP Tray Mode
2-64
This section explains how to change mode for the MP tray, the paper size
and type for each paper source, and how to select the paper source and
paper destinations.
The MP tray can be used in either of two modes — Cassette or First.
The MP tray feed paper differently depending on the mode:
• Cassette Mode (default)
The MP tray acts in the same manner as other paper sources.
The printer can feed paper from any paper source you command
on the printer driver. The cassette mode provides a faster printing
speed than the first mode.
• First Mode
The MP tray automatically feeds paper placed on the MP tray
overriding another paper source that is selected on the printer
driver. After all sheets in the MP tray have been used up
(approximately 100 sheets), paper will be fed from the paper
source originally selected. This mode is convenient to feed paper
of special size or type without reloading the current paper source.
However, the MP tray must be kept empty if you desire to feed
paper from the intended paper source.
1
Press [Menu].
Press ? or @ repeatedly until Paper
2
Handling > appears.
Press B.
3
Press ? or @ repeatedly until >MP Tray
4
Mode appears.
5 Press [OK]. A blinking question mark (?)
appears.
Press ? or @ to change Cassette to First.
6
7 Press [OK]. The MP tray mode is changed.
8
To exit the menu selection, press [Menu].
Paper Handling >
>MP Tray Mode
Cassette
>MP Tray Mode
? Cassette
ADVANCED OPERATION GUIDE