Network 1: Register Data From Drive Menu (9400); Network 2: Configure Menu (9914); Network 2: Configure Parameters Menu (9916); Network 2: Register Data From Drive Menu (9500) - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

Modbus Ethernet Communication
5.4 Parameter Assignment/Addressing
Network 2 Parameters
Table 5-17

Network 2: Configure Menu (9914)

Parameter ID
Network 2 Type 9915
Table 5-18

Network 2: Configure Parameters Menu (9916)

Parameter ID
Velocity Units 9924
Demand Scalar 9926
Aux Demand Scalar 9927
Network Timeout 9935
IP Address 9936
Subnet Mask 9937
Gateway Address 9938
Table 5-19

Network 2: Register Data from Drive Menu (9500)

Parameter
Data From Drive 01
Data From Drive 02
Data From Drive 03 to 64
66
Unit Default Min Ma
None
Unit Default Min
%
1 -125
1 -125
0 0
172.16.20
.17
255.255.0
.0
172.17.1.
1
ID Unit Default
9501 General Sta‐
tus
9502 Motor Speed
9503 to None
9564
Description
x
Designate the type of external network connected to the
drive:
• None
• Modbus
• DeviceNet
• Profibus
• Ethernet Modbus
• ControlNet
• Ethernet I/P
Max Description
Designate the units for velocity values from the drive:
• %
• RPM
• Hz
125 Set the scalar for input demand reference from the net‐
work.
125 Set the auxiliary scalar for input demand reference from
the network.
65535 Set the timeout for network determined to be non-re‐
sponsive.
Set the system TCP-IP address.
Set the system TCP-IP subnet mask.
Set the system TCP-IP address gateway address.
Min Max Description
Register data from drive parameter 1.
Register is not programmable.
Register data from drive parameter 2.
Register is not programmable.
Register data from drive parameters 3 to 64.
Registers are programmable.
NXGPro+ Communication Manual
Function Manual, AA, A5E50226719