Network Status (Auto Detect); Plc Setup Using Eds Files - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

3. The pick-list of data from drive variables appears. A 'number of active faults' is not an option
displayed in the pick-list.
Action: Manually specify the number of active faults.
Refer to table Data From Drive-Pick List Variables in section Parameter Assignment /
Addressing for a list of 'data from drive' pick-list variables.
4. Refer to appendix Output Data IDs and locate "number of active faults" in the tables.
Actions:
– Determine its data ID number (3000).
– Use the arrow or number keys to enter 3000 and press [ENTER].
– Ensure that the data ID is correct.
Table 9-21 Table of Completed Settings for Given Example
PLC Address or Register
Data from Drive 01 (not changeable)
Data from Drive 02 (not changeable)
Data from Drive 03
Data from Drive 04
9.5.8

Network Status (Auto Detect)

Network Status (Pulse Timeout)
A SOP flag is available to show the network status:
• For network 1: Network1CommOk_I
• For network 2: Network2CommOk_I
The SOP flag sets to "1" (true) when the network connection is operating normally, and "0" (false)
when it is not operating normally.
The network status is automatically detected. Detection time takes approximately 20
milliseconds..
If a longer network timeout is desired for a network that automatically detects the network
status, it must be implemented through SOP logic.
9.5.9

PLC Setup using EDS files

An EDS file is a device description file in a specified format. The format must conform to the ODVA
guidelines.
NXGPro+ Communication Manual
Function Manual, AA, A5E50226719
The display now shows "ManId-3000".
– The number of active faults will be sent to the PLC using register 'Data from Drive 04'.
– If the data ID number is not found, the error message "Invalid Id Entered" is displayed.
Data
General Status
Motor Speed
Output Power
Number of Faults
ControlNet Communication
9.5 Planning/Configuring
Scaling
16 bits
RPM
kW
0 to 128
185