Table 4-5 Network 1: Programmable Input Bits (Parameter Id 9603-9664); Table 4-6 Network 2: Programmable Input Bits (Parameter Id 9703-9764) - Siemens SINAMICS PERFECT HARMONY GH180 Function Manual

3. Scroll through the pick list until you come to 'Net Input Flag 1' and press [ENTER]. This setting
uses the first 16 bits of the possible 64 bits.
The corresponding bits from the drctry.plus file can be used in the SOP, as shown below:
;Network1Flag0_I Use bit 0 for Stop bit
;Network1Flag1_I Use bit 1 for Run Forward bit.
RunRequest_O = /Network1Flag0_I * Network1Flag1_I;Run drive using
bit 1, stop using bit 0
4. Select 'Net Input Flag 2' to use the second set of 16 bits, and continue on in the same manner
for the next set of 16 bits.
Note
• By choosing 'Data to Drive 03' as the write register, the PLC must now send 0x02 in register
'Data to Drive 03' to run the drive.
• To stop the drive, the PLC must send 0x01 in register 'Data to Drive 03'.
The pick-list variables and the corresponding programmable input bits are found in tables
Network 1: Programmable input bits (parameter ID 9603-9664) and Network 2: Programmable
input bits (parameter ID 9703-9764) for network 1 and 2, respectively.
Table 4-5 Network 1: Programmable input bits (parameter ID 9603-9664)
Pick list variable in 'Data to Drive
Reg nn' menus
Net Input Flag 1
Net Input Flag 2
Net Input Flag 3
Net Input Flag 4
Table 4-6 Network 2: Programmable input bits (parameter ID 9703-9764)
Pick list variable in 'Data to Drive
Reg nn' menus
Net Input Flag 1
Net Input Flag 2
Net Input Flag 3
Net Input Flag 4
NXGPro+ Communication Manual
Function Manual, AA, A5E50226719
Related Drctry.plus bits
Network1Flag0_I ~ Network1Flag15_I
Network1Flag16_I ~ Network1Flag31_I
Network1Flag32_I ~ Network1Flag47_I
Network1Flag48_I ~ Network1Flag63_I
Related Drctry.plus bits
Network2Flag0_I ~ Network2Flag15_I
Network2Flag16_I ~ Network2Flag31_I
Network2Flag32_I ~ Network2Flag47_I
Network2Flag48_I ~ Network2Flag63_I
Modbus Communication
4.2 Software Programming
27