Smartgen HGM400N Series User Manual page 24

No. Items
95 Disconnect OP Delay
96 Scheduled Start
Scheduled
97
Circulate
98 Auto Start Inhibited
Auto Start Circulate
99
Inhibited
100 Over Power
101 Date
102 Custom Sensor Curve
NOTE 1: The No. column is for HGM420N, and for HGM410N please deduct 5 for parameter No. on the basis of
HGM420N No. as HGM410N doesn't have the first 5 parameters.
NOTE 2: If "high temperature inhibit" is configured, or set auxiliary input as "inhibit high temperature stop" and this
input is active, when temperature is higher than the preset value, or high temperature alarm input is active, controller will
HGM400N Series Genset Controller User Manual
Range
(0-20.0)s
(0-1)
(0-1)
(0-2)
(1-31)
Start (0-7)
(1-23)h
(1-59)min
(0-30000)min
(0-1)
(0-2)
(1-31)
(0-7)
(1-23)h
(1-59)min
(0-30000)min
(0-2)
(0-6000)kW
(0-6000)kW
(0-3600)s
Set the date of controller.
(0-3)
Default
When disconnect
pressure and engine oil pressure is higher than
0.0s disconnect oil pressure delay, the genset is
regarded as start successfully and starter will
disconnect.
0 0: Disabled; 1: Enabled
0 0: No-load; 1: On-load
0 0: monthly; 1: weekly; 2: daily
1 Day (0: monthly is active)
0 Week (0: weekly is active)
0 Prohibit start time (h)
0 Prohibit start time (min)
30 Duration
0 0: Disabled; 1:Enabled
0 0: monthly; 1: weekly; 2: daily
1 Day (0: monthly is active)
0 Week (0: weekly is active)
0 Prohibit start time (h)
0 Prohibit start time (min)
30 Duration
0 Inactive; 1 Warn; 2 Alarm Shutdown
0
Over power setting value
304
Over power warn return
290
Over power delay
5
When power is higher than preset value and
duration exceeds than delay, over power
warning is active. Return and delay value can
be set.
0 Custom temperature sensor
1 Custom pressure sensor
2 Custom level sensor
3 Custom auxiliary sensor
0
Choose sensor which need to be set, input
every point (8 points need to be input)
resistance and corresponding value (or current,
voltage) of curve.
Description
conditions include
Page 24 of 38
oil