Smartgen HGM400N Series User Manual page 17

Pin Function
7 Digital Input 1
8 Digital Input 2
9 Digital Input 3
10 Digital Input 4
11 Engine Temp. Sensor
12 Oil Pressure Sensor
13 Current IA
14 Current IB
15 Current IC
16 Current COM
17 Magnetic Pickup
18 Charger D+
19 Aux. Output 4
20 Aux. Output 5
21 Aux. Output COM
22 Gen AC Voltage U
23 Gen AC Voltage V
24 Gen AC Voltage W
25 Gen N2
26 Mains AC Voltage R
27 Mains AC Voltage S
28 Mains AC Voltage T
29 Mains N1
NOTE: USB interface is parameter programmable interface, which can be programmed on PC.
HGM400N Series Genset Controller User Manual
Cable Size
2
1.0mm Ground connected is active (B-)
2
1.0mm Ground connected is active (B-)
Ground connected is active (B-);
1.0mm 2
Can be used as Level Sensor.
Ground connected is active (B-);
1.0mm 2
Can be used as Config. Sensor.
Connect
2
1.0mm
temperature resistance sensor.
Connect
1.0mm 2
resistance sensor.
Outside connected to secondary coil of current
2
1.5mm
transformer (rated 5A).
Outside connected to secondary coil of current
1.5mm 2
transformer (rated 5A).
Outside connected to secondary coil of current
2
1.5mm
transformer (rated 5A).
2
1.5mm See INSTALLATION in this manual.
Connect to speed sensor; Shielded wire is
0.5mm 2 recommended.
The other end of speed sensor connects to B-.
Connect to charging generator's D+ terminal. If
2
1.0mm
there is not this terminal, then hang it up.
The combination of terminal 19 and 21 is relay
1.0mm 2
normally open contact; rated 5A; Voltage free.
The combination of terminal 20 and 21 is relay
2
1.0mm
normally open contact; rated 5A; Voltage free.
1.5mm 2 Common terminal of auxiliary output 4 and 5.
Connected to U-phase of generator (2A fuse is
1.0mm 2
recommended).
Connected to V-phase of generator (2A fuse is
1.0mm 2
recommended).
Connected to W-phase of generator (2A fuse is
1.0mm 2
recommended).
1.0mm 2 Connected to N-wire of generator.
Connected to R-phase of mains (2A fuse is
2
1.0mm
recommended) (HGM410N without)
Connected to S-phase of mains (2A fuse is
1.0mm 2
recommended) (HGM410N without)
Connected to T-phase of mains (2A fuse is
1.0mm 2
recommended) (HGM410N without)
2
1.0mm Connected to N-wire of mains (HGM410N without)
Description
For
please see Table
9.
to water/cylinder
For
please see Table
to oil pressure
8.
set items
set items
Page 17 of 38