10-7-4 Grounding continuity
DANGER
Versana Balance – Basic Service Manual
5808768-100 English Rev.9
ELECTRIC SHOCK HAZARD. THE PATIENT MUST NOT BE
CONTACTED TO THE EQUIPMENT DURING THIS TEST.
Measure the resistance from the third pin of the attachment plug
to the exposed metal parts of the case. The ground wire
resistance should be less than 0.2 ohms. Reference the
procedure in the IEC60601-1.
Figure 10-2. Ground continuity test
1. GROUND PIN
2. OHMMETER
3. Versana Balance
4. ACCESSIBLE METAL PART:
•
MONITOR HOUSING
•
PEAR PANEL CONNECTOR
•
ANY CASTER/WHEEL SUPPORT
Electrical safety tests
System view
10-25