GE Versana Balance Basic Service Manual page 354

Replacement Procedures
8-4-8-3 Set Password
NOTE:
NOTE:
NOTE:
System
Upgrade
Whole disks
Only C disk
Reload Apps
NOTE:
8-24 System view
After the serial number is reset, the system will shutdown
automatically. Power on the system and complete the password
setting for use.For more information, please refer
configuration Wizard' on page 3-68
For R1.0.3, Drive D password and system password setting is
required when turning on the system for the first time or after the
software installation.
For R1.0.4 and higher, selecting password policy level, ADM
password setting, Disk Encryption setting, System Password
setting is required when turning on the system for the first time
or after the software installation.
Software upgrade will cause password reset, see
more information.
Table 8-3: Password Reset Policy
Disk Encryption
password
Yes
No
No
Please save the system password properly. User is required to
provide the system password to back office for remote
connection.
System ADM User
password password
Yes Yes
Yes No
No No
Versana Balance – Basic Service Manual
5808768-100 English Rev.9
to3-9-1 'EZ
for
Table 8-3
Database
password
Yes
No
No