3-4 Compaq StorageWorks SSL2000 Series Library Reference Guide
7. Attach the PTM to the master (top) unit using two bullet-nose
thumbscrews 1 and washers through the top two holes in the extrusion
(see Figure 3-3). Do not fully tighten the thumbscrews at this time.
1
Figure 3-3. Securing the PTM to the master unit
8. Align the two holes on the extrusion with mounting holes on the slave
unit and attach the PTM in place using two bullet-nose thumbscrews and
washers ( 1 Figure 3-4). Do not fully tighten the thumbscrews at this
time.
cc0030